Caen RFID R1280I, Technical Information Manual, Page: 22 / 83

CONFIGURATION MENU - skID Technical Information Manual 22
Buzzer
Use this section in order to set the buzzer parameters:

Power Up: beep at the power on of the reader
 Power Down: beep at the power off of the reader
 Inventory: beep at the identification of a tag
o
Success (ms): length of tone expressed in ms in case of success
o
Failure (ms): length of tone expressed in ms in case of failure
By default, all the Buzzer options are disabled.
Note that you can enable or disable the buzzer for any option independently so that the buzzer can be active
on more than one option simultaneously.
Y
Warning: To save the changes click on the SAVE button (check the green dot on the bottom
right side of the sidebar). On the main application window click on File  Disconnect . Power off
the reader, disconnect the USB cable and then power on the reader, the new settings are active.
Vibration
Use this section in order to set the vibration parameters:
 Power Up: vibration at the power on of the reader
 Power Down: vibration at the power off of the reader

Inventory: vibration at the identification of a tag
o
Success (ms): length of vibration expressed in ms in case of success
o
Failure (ms): length of vibration expressed in ms in case of failure
By default, all the Vibration options are disabled.
Note that you can enable or disable the vibration for any option independently so that the vibration can be
active on more than one option simultaneously.
Y
Warning: To save the changes click on the SAVE button (check the green dot on the bottom
right side of the sidebar). On the main application window click on File  Disconnect . Power off
the reader, disconnect the USB cable and then power on the reader, the new settings are active.