Caen RFID R1280I, Technical Information Manual

Page: 21 / 83

CONFIGURATION MENU - skID Technical Information Manual 21
Bluetooth Low Energy Options
By setting the COMM INTERFACE to Bluetooth , the window Bluetooth Low Energy Opt ions is enabled.
Y
Warning: To enable the Bluetooth Low Energy it is necessary to set the Bluetooth option in the
COMM INTERFACE and to upload the BLE firmware into the reader's Bluetooth module (see §
BT-BLE switching page 72)
In this section you can set the BLE communication parameters for iOS devices.
This operation is necessary to optimally configure the communication between the Bluetooth module and the
iOS operating system. These parameters are important, since they affect power consumption for both the
reader and iOS device, data transfer speed of the connection, and, in some cases, the stability of the
connection.
 MIN INTERVAL: ………….

MAX INTERVAL: ………………..
 COMM LATENCY: …………….
 COMM TIMEOUT: …………………
Y
Warning: To save the changes click on the SAVE button (check the green dot on the bottom
right side of the sidebar). On the main application window click on File  Disconnect . Power off
the reader, disconnect the USB cable and then power on the reader, the new settings are active.