CONFIGURATION USING THE WEB INTERFACE
-
Hex R1290I Technical Information Manual
36
Code:
alphanumeric characters. The “code” is the name assigned by the user to the custom program. When
the reader is turned on, if the profile is set to custom, among all the programs loaded by the user, the
reader starts the custom program named "code".
Parameters:
alphanumeric characters. This string can be used to assign values to the parameters defined by
the user in the custom program (e.g. Q=8; n=6; cycles=20, etc…).
Warning:
To save the changes click on the “
SAVE
” button. Note that all changes made via the web
interface are active only after the reboot of the reader. Click on
SYSTEM
option in the Web Interface panel
and then click on the “Reboot” button. After reboot, the new settings are active.
INFO
The INFO submenu options are the following:
Hardware Revision
: the hardware revision of the reader
Model
: the model name (e.g. R1290IU)
Serial Number
: the reader serial number (16 numbers)
MAC Address:
the reader MAC address
Distro Release:
the distribution firmware release of the reader
RF Model
: the internal RF module model, R1270C
RF Regulation
: the reader regulation (e.g. FCCUS)
