905K463452 (267r)
CAE LearningSpace
15
5.0 Connecting simulators
After the initial setups are completed: equipment, network, licensing, and system setup,
you can continue with connecting your simulators to your system.
Every CAE LearningSpace system can capture simulator signals of any kind.
The setup guide distinguishes between the following types of simulators:
•
CAE simulators with wireless connection
•
CAE simulators with a wired connection
•
Third-party (non-CAE) simulators
5.1 Connecting CAE simulators wirelessly
IMPORTANT
: To connect a CAE simulator wirelessly, a CAE Simulator Bridge is
required, which can be purchased separately.
In case of using wireless CAE simulators, do the following:
5.1.1 Connect a switch to Port 2 (A/V network) with an Ethernet cable.
5.1.2 Connect your CAE Simulator Bridge to the switch with an Ethernet cable.
5.1.3 CAE LearningSpace has to establish a wireless connection with the CAE
simulator, to check connection:
5.1.4 Go to
System
→
Simulators,
select the
Controls
cogwheel on the left panel
(under Wireless Bridges) and select the wireless network of the simulator.
In case the CAE simulator is not listed when trying to connect to the WiFi
network:
i.
Make sure the simulator is powered on.
ii.
Move the Simulator Bridge closer to the simulator.
Connect Server Port 2 (A/V network) on the back of the server
Port
2 (A/V network)
