KSACN0101CAC
KSACN0101AAA
Installation Instructions
Wired Controller
for Ductless Split Systems
Read and become familiar with these instructions before beginning
installation.
SAFETY CONSIDERATIONS
Read these instructions thoroughly and follow all warnings or
cautions included in the literature and attached to the unit.
Consult local building codes and National Electrical Code (NEC)
for special requirements. Recognize safety information.
This is the safety- alert symbol
!
!
. When you see this symbol on
the unit and in instructions or manuals, be alert to the potential for
personal injury. Understand these signal words: DANGER,
WARNING, and CAUTION. These words are used with the
safety- alert symbol. DANGER identifies the most serious hazards
which
will
result in severe personal injury or death. WARNING
signifies hazards which
could
result in personal injury or death.
CAUTION is used to identify unsafe practices which
may
result
in minor personal injury or product and property damage. NOTE
is used to highlight suggestions which
will
result in enhanced
installation, reliability, or operation.
ELECTRICAL SHOCK HAZARD
Failure to follow this warning could result in personal injury or
death.
Before beginning any modification or installation of this kit, be
sure the main electrical disconnect is in the OFF position.
Ensure power is disconnected to the fan coil unit. On some
systems both the fan coil and the outdoor unit may be on the
same disconnect. Tag the disconnect switch with a suitable
warning label. There may be more than one disconnect.
!
WARNING
EQUIPMENT DAMAGE HAZARD
Failure to follow this warning may result in equipment
damage.
Do not install the wired controller in an area subjected to
excessive steam, oil or sulfide gas. Doing so may cause the
controller to deform and/or fail.
!
CAUTION
INSTALLATION
Entrust the distributor or authorized professionals to install the
unit. Installation by unskilled persons may lead to improper
installation, electric shock, or fire. Re- installation must be
performed by authorized professionals. Non- compliance may
lead to electric shock or fire.
!
WARNING
Kit Contents: Confirm the following parts are included
No.
Description
Qty
Remarks
1
Wired controller
1
n/a
2
Installation and Owner’s
Manual
1
n/a
3
Screws
3
M4X20 (For mount-
ing on the wall)
4
Wall plugs
3
For wall mounting
5
Screws
2
M4X25 (For mount-
ing on switch box)
6
Plastic screw bars
2
For fixing on switch
box
7
The connective wires
group
1
24AWG
Field Supplied Components: Prepare the following assemblies
on site
No.
Description
Qty
Type
Remarks
1
Switch Box
1
n/a
n/a
2
Wiring Tube
(insulating sleeve and
tightening screw)
1
n/a
n/a
TABLE OF CONTENTS
SAFETY CONSIDERATIONS
1
. . . . . . . . . . . . . . . . . . . .
INSTALLATION ACCESSORY
2
. . . . . . . . . . . . . . . . . . .
INSTALLATION METHOD
2
. . . . . . . . . . . . . . . . . . . . . .
