14
Step
No.
Description
Picture
8
Make
sure
the
input cable is not powered.
Open the wire cover (circled in
the picture), insert the power
supply cables into the bottom
hole, and connect the cables
according to the signs as
specified on the wire cover
scheme.
It should be noted that there is
no device for fixing the input
cable, so you must leave
enough space for the cable to
avoid the cable from being
pulled by external forces, or you
can add a cable fixing device
which stabilize the input cable.
9
Close the wire cover and screw
up the wire cover with 4 screws
10
Close the front cover and the
installation is finished
6.9
Installation on stand
If the user decides not to install on the wall but on the dedicated stand, provided as accessory,
the following steps shall be performed. Please note that, in this case, the screws and fixing
accessories must be provided by the installer depending on the different conditions of the
installation site.
