Cabletron Systems MCC-D2PM Quick Reference Download Page 1

 

QR-1

 

MCC-D2PM QUICK REFERENCE

 

QR.1

SETTING JUMPERS

 

Location of Jumpers P1, P2, And P3 

(Default Settings)

 

 

 Copyright 1997 by Cabletron Systems, Inc., P.O. Box 5005, Rochester, NH 03866-5005

All Rights Reserved
Printed in the United States of America
Order Number: 9032133-01 July, 1997

The Complete Networking Solution

P1

P1

P2

P2

P3

P3

Summary of Contents for MCC-D2PM

Page 1: ...of Jumpers P1 P2 And P3 Default Settings Copyright 1997 by Cabletron Systems Inc P O Box 5005 Rochester NH 03866 5005 All Rights Reserved Printed in the United States of America Order Number 9032133 01 July 1997 The Complete Networking Solution P1 P1 P2 P2 P3 P3 ...

Page 2: ... MCC D2PM as shown in the table Use jumper P 2 to set the speed of the bottom ring labeled P3 and P4 when the MCC D2PM has been configured as two MAUs on separate rings Otherwise it is not used in single ring mode Ring Configuration Put Jumper P3 Sleeve Over MCC D2PM split into two rings Pins 2 and 3 Default setting All ports on the same ring Pins 1 and 2 NOTE If the MCC D2PM is split into two rin...

Page 3: ...pers and switches for future reference Jumper Setting P1 Sleeve over Pins 1 and 2 16 Mbps Sleeve over Pins 2 and 3 4 Mbps P2 Sleeve over Pins 1 and 2 Bottom ring speed 16 Mbps Sleeve over Pins 2 and 3 Bottom ring speed 4 Mbps P3 Sleeve over Pins 2 and 3 Ports divided into two rings Sleeve over Pins 1 and 2 All ports on the same ring Note Default settings set at the factory are in bold MCC D2PM P 3...

Page 4: ...LED lights YELLOW to indicate a 16 Mbps ring speed on the associated MAU An unlit LED indicates a ring speed of 4 Mbps on the associated MAU If the MCC D2PM has only one ring then the status of the top 16 Mb LED indicates the speed of the entire MCC D2PM The bottom LED will be off P1 P2 P3 And P4 Ports The P1 P2 P3 and P4 LEDs indicate the status of the associated lobe port as described in the tab...

Reviews: