12
12
3
Installation
3.4
Mounting the Applicator to the Printer
!
Attention!
Disconnect the printer from the power supply before mounting the applicator !
Ensure a stable standing of the printer !
Connect the compressed air only after mounting the applicator to the printer !
2
7
6
1
2
1
5
4
3
1. Applicator hang with the female part (1) of
hinges at the printer mounted hinges parts (2).
2. Connect SUB-D 15 male connector (6) to the
female connector (7) of the printer.
3. To secure the applicator to slip out of hinges
(4) loosen screw /4) and move metal part (3)
under the hinges. Tighten screw (4) again.
4. Swing the applicator to the printer.
5. Tighten the thumbscrew (5).
6. Move up stopper of the position of transport
safety for a free movement of the lift cylinder.
Mounting stopper
Fig. 12
Mounting and connection
!
Attention!
The pad will immediately be moved in the starting position !
Danger of crushing to hand and fingers by the moving pad !
Do not reach into the zone of the moving pad and keep long hair, loose clothes, and jewelry distant.
Danger of striking by the moving rods !
Do not reach or bend into the zone of the moving rods !
2
1
1 Check the vertical position of the stop valve
(2). (stop valve closed like picture)
2 Attach compressed air at the fitting (1).
3 Open the stop valve (2) (arm in direction of
flow).
4 Switch on the printer by the power switch.
Fig. 13
Compressed air connection
