7
2
Mounting
!
Attention!
Disconnect the printer from the electrical outlet before
mounting or removing the applicator.
2.1 Removing the Cover
2
1
Loosen screw (2) and remove cover (1).
2.2 Replacing the Print Roller
2
1
3
4
Turn the roller bearing (3) with the 2.5 mm Allen key out of the side plate
(4).
Pull the original print roller (6) from the shaft (1) through the side plate (4).
Insert the new roller (2) and slide it onto the shaft(1). Turn the roller slightly
until the hexagonal shaft engages the hexagonal socket of the roller.
Put the roller bearing (3) onto the axle of the roller and screw it into the
side plate (4).