14
15
6
Operation
Check all external connections.
Load the material. Ensure that the locking system is locked
"Operator's Manual" of the printer.
Open the shutoff valve.
Switch on the printer.
Press the
respectively
feed
at the printer.
A synchronization feed is released. The processed labels have to be removed manually. After a few seconds the
printer carries out a short backfeed to position the front edge of the next label at the printing line.
i
Note!
This synchronizing also has to be carried out when the print job has been interrupted with the cancel key.
Synchronizing is not necessary when the print head was not lifted between print jobs. This also applies if
the printer was powered off between print jobs.
Start a print job
Start the labelling process via PLC interface.
Error messages during labelling process are shown in the display of the printer
6.1
Cleaning
!
Attention!
Never use solvent and abrasive.
Clean the outer surfaces with a multi purpose cleaner.
Especially the surface of the suction plates needs regular
cleaning as left over debris is likely to adhere to the pad
preventing an optimal label take over.
Fig. 12
Cleaning the suction plate
