12
12
5
Operation
5.1
Standard Operation
Before commencing the labeling process check that the underlying connection are active.
Load material. Ensure that the locking system is locked
"Operator's Manual" of the printer.
Switch on the printer.
Press the
feed
key at the printer.
A synchronization feed is initiated. The processed labels need to be removed manually. After a few seconds the
printer carries out a short back feed to position the front edge of the next label at the printing line.
i
Note!
This synchronizing also has to be carried out when the print job has been interrupted with the cancel key.
Synchronizing is not necessary when the print head was not lifted between print jobs. This also applies if
the printer was powered off between print jobs.
Start a print job
Start the labelling process via PLC interface.
Error messages during labelling process are shown in the display of the printer
5.2
Cleaning
!
Attention!
Never use solvent and abrasive.
1
2
3
4
Clean the outside surfaces and
transport belts with multi purpose
cleaner: Area 1
Clean the fan area with a soft brush
and/or a vacuum cleaner: Area 2
Use glass cleaner to clean the reflex
sensor: Area 3
To clean the pressure roller use a
special roller cleaner: Area 4
Fig. 7
Cleaning