37
Assembly of the pliers assembly
When the lifting cylinder (2) has been replaced, insert it and fasten it with the nut (12) to the holder on the base plate.
Mount the sensor brackets (4) and the throttle valves (3) on the lifting cylinder (2).
Set throttle valves (3).
1.1
1.2
14.1
14
1
Lightly grease the guide (1.1) on the base plate (1).
!
Attention!
Use only a plastic grease to grease the running
surfaces on the guide.
cab Part No.: 5984552.001
Move the rod linkage (14) with the groove on the center piece
place to the guide (1.1) of the base plate (1).
Insert the pins of the cam wheels (14.1) of the connecting rod
linkage (14) into the guide (1.2) in the base plate (1).
Press the connecting rod linkage (14) completely onto the
guide (1.1) on the base plate (1).
Fig. 40
Insert connecting rod linkage
2.1
13
14
2
19
1
Pull the piston rod (2.1) out of the lifting cylinder (2) and screw
the nut (13) onto the piston rod (2.1) up to the end of the thread.
Screw the piston rod (2.1) into the threaded hole in the
connecting rod linkage (14).
Insert a feeler gauge (19) with a thickness of 0.05 mm between
the lower stop of the base plate (1) and the connecting rod
linkage (14).
Press the connecting rod linkage (14) with the screwed-on
piston rod (2.1) against the stop in the base plate (1).
Now carefully screw the piston rod (2.1) into the connecting
rod linkage (14) so that the feeler gauge (19) can be pulled out
easily.
Turn the nut (13) clockwise until it locks the position of the piston
rod (2.1) in the connecting rod linkage (14).
Insert axles (16) and slide pliers jaws (15) on.
Push the shafts for the punch attachment on the connecting rod
linkage (14) into the guide grooves on the framing.
Attach the covers (17) of the pliers jaws (15) with the screws
(18).
Attach the cover (9) with connections with the screws (10) and
(11) to the base plate (1).
Fig. 41
Set the stroke on the cylinder 'flag'