33
6.13
Setting of the End Position Dampener
i
Note!
The end position dampening of the lifting cylinders are set by default and will normally not need to be
adjusted.
2
1
The end position dampening of the cylinder z is for relief of
mechanical strain particularly at higher speeds or when using
a larger mass.
The end position dampening is best set up so the piston
reaches both ends securely but does not impact anything
harshly.
By raising the end position dampeners the speed of the piston
is reduced and so the overall time cycle is increased.
At cylinder (1) turn the setting screw (2) clockwise to
increase the end position dampening.
At cylinder (1) turn the setting screw (2) counter-clockwise
to decrease the end position dampening..
Fig. 35
End position dampening cylinder 'Z'