11
3.4
Mounting and Demounting the Cover
To initialize the applicator or perform adjustments it is required to remove the cover. Once content with the changes reattach
the cover.
!
Warning!
It is only permitted to use the applicator with a mounted cover (2).
Only in the case of servicing, adjustments and maintenance may the cover be removed.
2
3
1
1. Loosen the screw (3).
2. Lift off the cover upward (2).
3. Once the service or maintenance has been
completed lower the cover over the cylinder.
4. Guide cylinder (1) through the hole in the
cover (2).
5.
Tighten the screw (3) to fix the cover (2) in
place.
Fig. 7
Cover
3.5
Releasing the Transportation Lock
Before the applicators are delivered, a transportation lock (4) is mounted on the rod (1).
For the labeling operation, the transport lock (4) is pushed onto the stopper (2).
The stopper (2) brakes the lifting movement and triggers the flag formation.
2
4
3
1
Releasing the transportation lock
1. Loosen the screw (3) of the transport lock (2).
2. Move the transport lock (4) on the rod (1) to the
stopper (2).
1.
Tighten the screw (3) of the transport lock (2) to fix
the position.
If the position of the stopper (2) is changed to change
the application height, the transport lock (4) must also
be moved.
„3.18 Setting the Application Height“
Fig. 8
Transportation Lock
