12
12
4
Error Messages
4.1
Error messages of the printer
For detailed information about printer errors
Operator's manual of the printer
Error treatment:
Clearing the error results.
Press the
feed
key to synchronize the label feed, remove the left over labels manually.
Press the
pause
key to quit the error state.
After error correction, the label causing the error will be reprinted.
4.2
Error messages of the applicator
The following table contains an overview of error messages and their possible causes. It also suggests methods to
resolve the problem:
Error Message
Possible Cause
Air pressure ins.
Compressed air is switched off
Pressure to low < 4 bar
Pressure to high > 6 bar
Label not depos.
Label has not been placed onto the product; after the pad has moved back the label is
still sticking to the pad.
Lower position
Pad is not in the starting position when the printer is switched on.
Pad has not reached the starting position within 2s after the pad has left the labelling
position.
Pad has left the starting position without authorization.
Process Error
There has been no change of state of the upper sensor of the cylinder from the start of
the labelling process and the signal of the labelling position sensor.
Refl. sensor blk.
There has been no change of the switch state at the upper sensor at the cylinder
between the start of the labelling process and the signal from the labelling position
sensor.
Vac. plate empty
Label has not been picked up properly by the pad; or label fell off the pad before it could
be placed onto the product.
Upper position
Pad has not reached the starting position within 2s after the pad has left the labelling
position; or pad has left the starting position unauthorized
Table 3
Error messages of the applicator
Error treatment:
Clear the error results
Press the
pause
button to quit the error state.
i
Note!
In the case of errors check the service manual for adjustments and settings.
!
Warning!
After the error has been resolved the pad will immediately move back to the starting position!
Danger of injury to hands and fingers by the moving pad!
Do not reach into the area of the moving pad and keep long hair, loose clothes, and jewelry away.
After error correction, the printing of the label causing the error cannot be repeated without restarting the print job
except the error "
Vac. plate empty"
.
In this case, the last label will be printed again after resolution via the
pause
key
and then pressing the Enter button .
In the application mode "Apply/Print" sends the signal "Print first label" or press the button
to send a printed
label to the tamp.