18
18
6.6
Mounting the Pad
2
7
3
4
8
6
5
1
1. Slide the pins (3) into the holes of pad (4)
by lifting the pad to pad holder (1).
2. Fix the pad with the screws (2) to the pad
holder (1).
3. Insert the vacuum tube (5) and the
blowing air tube (6) into the appropriate
push-in-fittings (7,8) of the pad.
Fig. 11
Mounting the pad
!
Attention!
To avoid possible collisions of the pad with other parts of the printer-applicator system, please roughly
align the pad in all directions (
„7 Adjustments“) before connecting the applicator to the compressed
air supply!
6.7
Mounting the Blow Tube
1
2 3
Fig. 12
Mounting the blow tube
It is possible to rotate the blow tube to optimize the direction of the support air for the take over procedure of the label
from printer to applicator.
1. Loosen screw (1).
2. Put in the blow tube (3) into the hole A (2).
3. Tighten screw (1) gently to secure it.
Summary of Contents for 4114 Series
