7
3.1
Cleaning by the Operator
The following cleaning work is described in the “Operator's Manual“:
•
cleaning the device
•
cleaning the printhead
•
cleaning the print roller
3.2
Cleaning the Label Sensor
3
1
2
3
4
5
Fig. 2
Cleaning the label sensor
Danger!
Risk of death via electric shock!
Before opening the housing cover, disconnect the device from the mains supply and wait at lease one
minute until the power supply unit has discharged.
1. Unplug the printer from the electrical outlet and remove the cover of the printer
2.2 Cover dismount / mount.
2. Remove the material from the printer.
3. Disconnect the cable (4) and connector (5) from the label sensor (3) .
4. Loosen screw (2) with the Allen key (1).
5. Push the label sensor (3) in arrow direction and pull it out.
6. Clean label sensor and sensor units (3) with brush or cotton swab soaked in pure alcohol.
7. Move label sensor (3) against the arrow direction in the former position.
8. Connect cable (4) with connector (5) .
9. Mount cover and restore all connections.
10. Adjust label sensor
Operator's Manual.
11. Tighten screw (2) .
3 Cleaning
