C2R Colibri 5 Series, User Manual

Page: 124 / 168

Colibri serie 5 : User’s guide
© 2000-2008 C2R Technologie, Sarl. All rights reserved.
124 124
Rev. C
the commands (indicated by an asterisk (*) on the programming pages).
Test Menu
When you scan the Test Menu
On code, then scan a programming code in this manual, the
imager displays the content of a programming code. The programming function will still occur, but
in addition, the content of that programming code is output to the terminal.
Note: This feature should not be used during normal imager operation.
2D PQA (Print Quality Assessment)
Two-dimensional Print Quality Assessment (2D PQA) is a feature of C2R‟ image readers where
the data from the successful read of a 2D bar code symbol is augmented with lines of text that
both identify the symbol, and also report graded measurement parameters obtained from it.
2D PQA Reporting
C2R' 2D PQA reporting can be enabled in two different modes: Full Report or Screening. (To see
displayed results, Microsoft® Notepad, a word processor/editing program, C2R ScanTools is
recommended.)
If you are using C2R Scantools, you can enable Full Report, a listing of all of a symbol's
identifying information, measurements, and corresponding grades, by typing the following menu
command:
2D_PQA1
Note: The PQA report is sent out as a second data/beep sequence after the barcode data.
The report has its own Hand Held Products code ID of >(0X3E) so it can be uniquely identified.
You can exit Full Report mode by either typing the menu command, 2D_PQA0, if you are using
Quick*View, or by scanning the following barcode:
2D_PQA0
Note:
For additional information on interpreting your read results, please refer to C2R Quick
Check 2D Print Assessment User‟s Guide.