CAST XFP ANALOGUE ADDRESSABLE FIRE ALARM PANEL
Page 12 of 16
Commissioning/Programming Quick Start Guide
Approved Document No. DFU5020010 Rev 4
4.6.2
Assign an Input Device to a Zone
An input device is any device that can signal an event such as ‘fire’, ‘fault’, etc. to the fire alarm panel,
e.g. smoke/heat detectors, MCPs
and the input channels of I/O units.
Click on the
Loop Summary
tab to open the
Loop Summary
window.
For each input device, click on the drop-down menu in the
Zone/Group/Set
column to assign a
device to a Zone (see FIG.4).
Note:
In order to make any changes to the Zone/Group/Set data in the
Loop Summary
window,
click on the
Enable Type/Zone Changes
box.
FIG.4 – Loop Summary Window
