10
Assembly & Setup
– XC3 Console
Locate a convenient
central
surface of sufficient size to fit the console to. Ensure that the location
does not interfere with factory equipment or block the view to gauges
or the driver’s field of view.
Always put safety first.
Place the appropriate mount around the bar or mounting point/surface on the tractor/RTV.
Never over-tighten the fasteners on the plastic mounts.
Carefully route the power cable from the console to the battery on the ATV/RTV/Tractor.
Take care
to avoid “pinch points” and hot surfaces such as the exhaust system.
Connect the round male power cable to power socket on the bottom of the console.
Before operating, connect power to the implement being operated (Spreader/Sprayer/Pasture
Meter). The XC3 console should connect wirelessly to the spreader/sprayer or Pasture Meter
It is advised that the console power is plugged/unplugged using the round plug in the power line.
Note:
While every effort has been made to protect the console from the
ingress of water, users are advised to remove the console from
the ATV/RTV before washing down the vehicle. No hard water
should be directed near the console at any time.
Step Two
Step Three
Step One