BZBGEAR BG-UM44-100M-KIT, User Manual, Page: 14 / 43

- 12 / 30 -
8. IR Cable Pin Assignment
IR RECEIVER IR BLASTER
IR Receiver Signal
9. EDID Management
This Matrix has 21 factory defined EDID settings, 2 user-defined EDID modes and 8 copy EDID
modes. You can select defined EDID mode or copy EDID mode to input port through on-panel
button, ASCII control or Web GUI.
On-panel button operation:
On the initial OLED display screen, press “MENU” button to enter the
EDID setting interface, press “UP/DOWN” button to select the required EDID, and press the
“ENTER” button. A prompt “copy to input :” will appear. Then press “UP/DOWN” button to
select the input port you need to set, and press “ENTER” button again to confirm
this operation.
RS-232 control operation: Connect the Matrix to PC with a serial cable, then open a Serial
Command tool on PC to send ASCII command “s edid in x from z!” to set EDID. For details,
please refer to “EDID Setting” in the ASCII command list of “12. RS-232 Control Command”.
Web GUI Operation: Please check the EDID management in the “Input page” of “11. Web
GUI User Guide”.