5
7.IR Control system
(IR Call
-
back of Matrix and Source Devices)
The matrix is not only a
switcher and extender of
multiple HDMI signals to
multiple HDMI receivers
located remotely, it also
passes IR control signals
through the IR call
-
back
system to the matrix and
HDMI sources for full,
independent control of all
connected inputs from
output locations.
Two
-
way IR Call
-
back
Between matrix, Sources and
Displays from Multiple
Locations.
A key feature on the matrix is
discrete IR control of the matrix, sources and displays from any location
–
so inputs
at the matrix end can be
controlled at a display location and displays can be controlled at the matrix location.
This is accomplished by placing a series of IR Emitters on devices to control and IR
Receivers at all locations you wish to control from to enable the IR signal to travel
both ways via the single Cat5e/6/7 cable.
IR control is divided into two kind of control ways as below.
Insert the 3.5mm IR receiver cable into IR INPUT ports at the rear of the matrix. At
the same time, insert the 3.5mm IR blaster cable into IR OUTPUT ports at the rear of
the matrix. At the display, the user connect HDBT Receiver device at the matrix
