BYD BYD5030XXYBEV2, Manual

Page: 101 / 252

4
A
p
p
lic
atio
n
an
d
D
ri
v
in
g
4-2 Starting and Driving 101
4-2 St arting and Dri vi ng
Circumstances Where Motor Cannot Be Started Normally

The failure to start the motor normally after the START/STOP button is pressed may
be caused by the following reasons:
The electronic intelligent key does not work and the intelligent key system warning
light on the combination instrument flashes, indicating that the key battery may
have run out. Hold the electronic intelligent key and move it close to the
START/STOP button to start the vehicle. Please refer to “Start the vehicle using
the electronic intelligent key with dead battery” this chapter for details. Contact a
BYD authorised service provider to replace the battery.
If you need to start the motor repeatedly in a short time, wait for 10s before each
motor starting cycle. In the case of failure to start the motor, the orange indicator
on the START/STOP button will flash.
The steering lock is stuck if the green indicator on the START/STOP button
flashes. To release steering lock, press the START/STOP button and slightly
shake the steering wheel at the same time.

Except for above-mentioned causes, the PEPS system also fails to work normally
under some conditions due to different service environments. Please refer to “PEPS
System” in this chapter for details.
PEPS System

If PEPS system is used, the vehicle can be started only when the electronic intelligent
key is carried with the driver.

If the driver is unaware that electronic intelligent key has been carried away from the
vehicle, the shut-down motor cannot be restarted.

The driver should confirm that the vehicle is powered off before he/she gets off of the
vehicle.