BYD ATTO 3 2022, Owner'S Manual

Page: 90 / 201

89
USING AND DRIVING
05
CAUTION
•For precautions on the use of
discharge connection devices, refer
to article 3 of charging precautions,
charging precautions for charging
equipment.
•Before discharging, confirm the
vehicle's power and estimate the
remaining driving range.
•Before VTOL discharging, ensure that
the load is turned off.
WARNING
•
When discharging, do not touch
the discharge power strip, in-car
discharge socket, or the metal end of
the vehicle's charging port.
•
If anything unusual is noticed during
discharge, such as smoke or smell,
stop it immediately.
• Discharging safety warnings are the
same as charging safety warnings
(refer to charging instructions).
• Store the product in a cool dry place
when not in use.
•
When discharging, do not place the
device in the trunk, under the front of
the car or near the tires.
•
When using it, avoid it getting rolled
over by the vehicle, dropped, or
trampled on.
•
Never drop the device. Never move
it by pulling it directly by its cable.
When moving the device, it needs to
be handled with care.
• Never use the discharging equipment
if the power supply strip cable
becomes soft, the discharging nozzle
cable is worn out, the insulation layer
is cracked, or in case of any other
damage.
WARNING
•
Never use the equipment when the
discharging connector or power
supply strip is disconnected, broken,
or there is any sign of surface damage.
External Discharge
Discharging Discharging
• Before discharging, disable the anti-theft
function.
• Unlock the charge port cover, and open
the cap and the cover.
• Before discharging:
• Ensure battery capacity is not below
15%.
• Ensure the VTOL connecting device
casing is not cracked, and its plug is
free from rust or obstructions.
• Make sure the port is free from
moisture or dirt, and the metal
terminals are not damaged and free
from rust or corrosion.
• Do not discharge if any of the above
conditions is found.
• Connecting device:
• Connect the VTOL device to the port.
The power strip indicator lights up
when the strip is powered and ready
for use.