PROTECTION & SAFETY
36
2021/07 - Version: C - Code : 34681
2.
Counterweights
Configurations A and B: counterweights
Install the counterweights on the beam on the separating pit wall side, by clipping the straps onto the back of
the beam.
Roll the cover apron out over the water and adjust so that the
counterweights are 10 cm above the pool floor.
Validate this setting by rolling the cover up : the counterweight should
not touch the cover apron.
3.
Inéo deflectors
Trim the ABS deflector according to the length of the slat apron before mounting it.
As a guideline, for PVC slats:
Pools less than 10m long, no need to trim the deflector.
Pools between 10m and 14m pools, cut the first section off the Inéo deflector.
Pools longer than 14m, cut the first and second sections off the Inéo deflector.
Check the length of the deflector after the cover is rolled up, the cover apron should not be in contact with the
guides.
Rotate the gib by 90° to insert it the groove on the beam. Tighten the nuts (5) to fasten the deflector to the beam.
Ref
Description
Qty
1
¼ turn gib
2
2
U-shaped SS frame
2
3
Strap attachment bar
1
4
M 6 washer A4 SS
2
5
H nut 6 A4 SS
2
6
ABS guide for deflector
2
7
Hexagon socket button head
screw M 4 x 8 A4 SS
4
8
ABS deflector
1
9
Pozidrive countersunk screw ST
3.5 x 9.5 A4 SS
4
