AIR-EAGLE
®
XLT PLUS
REMOTE STOP SWITCH
900 MHz RF Transmitter
MODEL 497-5100-CHx-DC
INSTALLATION
1.
Mount transmitter in cab of dozer where operator will have
easy access to the STOP button and can see LEDs.
2.
Select Dozer Log-In Channel Number and Receiver Log-In
Options
3.
Install external antenna on vehicle roof at least 3 feet from
any other antenna and connect the ant
enna’s coax plug
onto the TNC connector on the side of the transmitter.
4.
A ten foot 2-conductor pigtail has been provided for DC
power.
DC power should be wired directly to the dozer
battery!!
(Black = -9-36VDC / Red = +9-36VDC) Note! Be careful to
observe polarity.
5.
Make sure that the base receivers and/or repeaters are
properly installed and powered up prior to attempting to
“Log-In”
DOZER LOG-IN CHANNEL &
RECEIVER LOG-IN OPTIONS SELECTION
TERMINAL STRIP WIRING INFORMATION
Note -This unit has been pre-wired at the factory
– the following
information is for reference only.
TERMINAL STRIP WIRING (TER1)
Terminal 1
Negative (-) 9-36VDC INPUT
Terminal 2
Positive (+) 9-36VDC INPUT
Terminal 3
Log-In Button (N/O)
Terminal 4
Log-In Button (Common)
Terminal 5
Stop Button (N/O)
Terminal 6
Stop Button (Common)
Terminal 7
Not Used
Terminal 8
Not Used
Terminal 9
Ch.1 Relay (N/O)
Terminal 10
Ch. 1 Relay (Common)
Terminal 11
Ch. 1 Relay (N/C)
Terminal 12
Ch.2 Relay (N/O)
Terminal 13
Ch. 2 Relay (Common)
Terminal 14
Ch. 2 Relay (N/C)
Terminal 15
N/O Relay 3
Terminal 16
C Relay 3
Terminal 17
N/C Relay 3
Terminal 18
Not Used
SPECIFICATIONS
Power Supply
External 9-36VDC from mobile vehicle
Maximum Number of
Transmitters
8 Transmitters to 1 Receiver
Transmit Frequency
900 MHz - 74 Channel Auto-Select
RF Output Power
1 Watt
Transmit Range
Approximately 4500 feet
USING SEL1 DIP SWITCHES:
DOZER LOG-IN CHANNEL NUMBER
Dozer
Channel
SW1
SW2
SW3
CH.1
(default
)
OPEN
OPEN
OPEN
CH.2
CLOSED
OPEN
OPEN
CH.3
OPEN
CLOSED
OPEN
CH.4
CLOSED
CLOSED
OPEN
CH.5
OPEN
OPEN
CLOSED
CH.6
CLOSED
OPEN
CLOSED
CH.7
OPEN
CLOSED
CLOSED
CH.8
CLOSED
CLOSED
CLOSED
RECEIVER LOG-IN OPTIONS
Receiver Selection
SW5
SW6
RECEIVER 1 ONLY
(default)
OPEN
OPEN
RECEIVER 2 ONLY
CLOSED
NOT USED
EITHER RECEIVER
OPEN
CLOSED
Note
– SW4 is not used and should be left open
