Butterfly B1501B/T, Operation And Service Manual

Page: 44 / 94

P a g e | 44
Butterfly B1501B/T - Single Head 15 Needle Embroidery Machine Manual
9.3 E
RROR
C
ODES
EMB Light not on but Pull Bar! The current embroidery pattern has not been
queued. Press the red button with the needle
emblem on the bottom left of the screen. The
message “Confirm emb?” should appear on screen.
Press the check mark to queue embroidery pattern.
Stop not in place! The main shaft has to be at 100 degrees. Please
move the main shaft manually, or use the red STOP
key to ask the machine to move the motor
automatically (if that software option is active,
which it is by default). To move it manually, push
the large black knob in and turn it to the left, and
either look through the small glass portal or watch
the LED light at the bottom of the control panel that
says 100, until the light turns on.
Trimming not in place! The trimming knife (movable knife) might be stuck
and did not return to its resting position. Please
press the red STOP button to ask the machine to
attempt to move it home. If it still cannot move,
then check if any threads are causing it to jam, and
remove all thread pieces and clean the area. If it is
still jammed, remove the needle plate and inspect.
Needle Position Abnormal! The head of the machine is not perfectly centered
over one of the 12 color change locations. Please
turn the small knob of the color change motor, to
manually move the head left and right. When you
are on a valid location, then one of the LED lights at
the bottom of the control panel will light up, the
light with a picture of three needles. Also, on the
graphical screen at the top right, there will be a
colored square indicator that changes from 1-12 if
centered, or a question mark “?” if the head is in-
between colors.
Color change time out! The color change motor mechanically jammed
while trying to move the head to a different needle.
Please locate the cause of the jam and clear it, then
move the head manually by turning the color
change motor knob, to check if cleared.
Thread break detected! The thread broke while sewing and no more thread
is being pulled. If the thread is not broken, then the
wheel sensor is not spinning or not spinning
enough, or sensitivity is set too high in software.
Check if the thread is running smooth and through
every part of the upper thread area.
Back to head! The machine was asked to back up stitches all the
way to the first stitch, and it cannot back up any