Butterfly B1501B/T, Operation And Service Manual

Page: 33 / 94

P a g e | 33
Butterfly B1501B/T - Single Head 15 Needle Embroidery Machine Manual
4.2 B
ASIC
C
ONTROL
P
ANEL
O
PERATIONS
Generally, there are very few operations needed to run the Butterfly embroidery machine. We
will simplify the learning process by only showing the Basic operations on the control panel in this
section and show further advanced (but rarely used) operation on another section.
4.2.1 Load design from USB / Memory stick
The first step to embroidering a design is to load it into the Butterfly control panel. You will
need to save your design from your PC onto a memory stick. The standard format is the Tajima DST
format. Please refer to your software manual on how to save the designs as DST.
Once the design is saved onto the stick:
1. Insert USB in 1 of the 2 ports on right side of the display. Wait for a beep.
2. On screen 1, press the yellow flower button to access USB memory.
3. Select your desired design
4. Press check mark on dialogue box.
5. Enter design name using number pad.
6. Press check mark to transfer design to machine memory. Wait for a beep.
4.2.2 Load design from memory (internal memory)
Once the design is loaded off the USB stick (see previous tutorial) and on the Butterfly internal
memory, then it can be loaded to embroider.
1. On screen 1, select desired design off machine memory. 8 are displayed at a time.
2. Use arrow buttons to change to the next design page if not on page 1.
3. Once desired design is highlighted, it has been loaded from machine's memory.
4.2.3 Color Changes
Once the design is confirmed you can program color changes.
1. On screen 3, colors are displayed in descending order by which they are stitched.
2. Colors are assigned a number that correspond to the thread colors on thread tree.
3. Press desired number to assign a needle. Once selected, it will automatically move to the next
color in sequence.
4.
Repeat until all required needles have been assigned.
4.2.4 Changing Orientation of Design
You can change the orientation, (mirror/rotate) by performing the following.
1. On screen 2, locate the “P” button.
2. Press the button to change to desired orientation.