17
4.
Remove any sidespin by using one of the Sidespin Buttons (7 or 8).
5.
Remove backspin by using the right Spin Button (10)
6.
Remove topspin by using the left Spin Button (9).
IMPORTANT:
These adjustments only work when the Calibration function is activated (CA shows on
the display). All Calibration settings are saved in memory, so settings from the previous Calibration
will be shown when you activate Calibration the next time. Calibration is dependent upon the head
working correctly, especially the wheels spinning. Check for proper head function by powering off
and on the robot, and carefully observing the head during the initial orientation procedure where the
Deflector Plate moves left, then right, and then down, followed by all wheels spinning forward for about
2 seconds. If the Deflector Plate does not move accordingly, or all wheels don’t spin, then it is unlikely
that Calibration can resolve any issues and further troubleshooting to identify the cause of the issues
is called for.
To exit Calibration function, press Stop.
The Remote Switch
The small wireless remote (looks similar to an automobile key fob) has a
range of 4–5 m (13–16 feet) and has the following functions:
1.
If Ball/Min on the Control Panel is set to 00, pushing the top button (A)
of the remote will throw 1 ball of the Exercise shown on the Control Panel
(similar to Sampling a ball as discussed on page 7).
2.
If Ball/Min on the Control Panel is not set to 00, pushing the top button
(A) of the remote will cause the Exercise shown on the Control Panel to
start playing at whatever frequency the Ball/Min set for (same as press-
ing Start on the Control Panel).
3.
The 2 buttons in the middle increase (B) or decrease (C) Ball/Min by 1 increment for each press. Or
hold these buttons down for rapid acceleration of Ball/Min.
4.
Press the bottom red button (D) to stop play (same as Stop on the Control Panel).
Linking The Remote To The Control Panel
Each remote is linked to an individual Robot body. This linkage is done at the factory and each Robot
and Remote pair is kept together throughout the manufacturing pro cess. In case you buy more
Remotes or a new one, you need to link each Remote to your Robot. Here are the steps to perform the
Linking procedure:
1.
Press Stop on your Control Panel if play is not already stopped. If in Memory Mode (E_ _ is showing
on the display), press both Step Buttons (18 & 19) to quit Memory Mode.
2.
Hold down the Save button until L_ _ appears on the display. The number after the L provides a
countdown of the time remaining (in seconds) for the Linking procedure.
