Page 38 of 61
INSTRUCTION, USE AND
MAINTENANCE MANUAL
EN
Fit the clip weight of the chosen value at “12 o'clock” on
the outside of the wheel. Press again button
to
position the wheel for the fitting of the 2
nd
clip weight.
Fit the clip weight of the chosen value at “12 o'clock”
on the outside of the wheel. Press button
to
highlight the value of the weights to be fitted on the
inside of the wheel.
Repeat the above steps for the weights to be fitted
inside the wheel.
At the end perform again a checking spin to see that
you have applied the weights correctly.
13.8.3 Weights hidden behind spokes mode
Adhesive correction weight positioning may not look
attractive on some types of rims. In this case, "weights
hidden behind spokes" mode can be used: it splits any
correction weight on the outer side into two parts to
be hidden behind rim spokes. It can be used in ALU-
S mode.
Proceed to ALU-S unbalance measurement displaying
by performing a standard wheel spin.
Once detected the unbalance values, verify that the
machine displays the ability to use the "spokes" op-
tions (
Fig. 30 ref. 4b
). Press button
to shift to
the next screen page.
Press button
to enter the relevant function. On
the monitor the next screen page will be displayed:
1296-M024-01
LIBRAK350 - LIBRAK350PRO
