INSTRUCTION, USE AND
MAINTENANCE MANUAL
Page 31 of 61
EN
13.6.1 Manual setting of wheel dimensions
In case the operator wants to edit and/or manually
enter the wheel dimensions, proceed as follows:
- from the desired measurement mode screen, press
the button
until highlighting with yellow the
field to modify/edit;
- press the buttons
or
until reaching the
desired value;
- press button
to shift to the next value.
After entering all the required measures, you can spin
the wheel by pressing the button
and closing
the protective guard.
In case the distance-diameter caliper was disabled, the
displayed page for detected unbalance is as follows:
Fig. 32
1
2
In this screen page,in addition to the information of
the detected unbalance, there are measurements in
mm where you must remove the gauge arm (
Fig. 32
ref.
_
1-2
) to apply the weights inside the rim.
13.7 Standard balancing programs
13.7.1 Static
The STATIC program permits balancing wheels by fit-
ting adhesive weights on the outer and inner sides of
the rim. Enter the measurements (see Par. 13.2.1 or
13.6.1) and proceed as described in Par. 13.5.
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
13.7.2 Static-1
STATIC 1 function is a procedure that offsets wheel
vibrations using a single weight with clip on a single
plane positioned exactly at “12 o'clock”.
Enter the measurements (see Par. 13.2.1 or 13.6.1) and
proceed as described in Par. 13.5 "Dynamic balancing"
(wheel inner side only).
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
LIBRAK350 - LIBRAK350PRO
1296-M024-01
