INSTRUCTION, USE AND
MAINTENANCE MANUAL
Page 13 of 61
EN
9.0 MACHINE ASSEMBLY
EACH MECHANICAL INTERVEN-
TION MUST BE CARRIED OUT BY
PROFESSIONALLY QUALIFIED
STAFF.
After having freed the various components from the
packing check that they are complete, and that there
are no anomalies, then comply with the following in-
structions for the assembly of the components making
use of the attached series of illustrations.
9.1
Anchoring system
The packed machine is fixed to the support pallet
through the holes prearranged on the frame and in-
dicated in the figure below. Such holes can be used
also to secure the machine to the ground, using floor
anchors (not included in the supply). Before carrying
out the definitive fixing, check that all the anchor points
are laid down flat and correctly in contact with the fix-
ing surface itself. If not so, insert shimming profiles
between the machine and the fixing lower surface, as
indicated in
Fig. 4
.
IT IS MANDATORY TO SECURE, IF
WHEELS WEIGHING MORE THAN
30 KG / 66 LBS ARE USED.
a
= 270 mm / 10.63”
b
= 480 mm / 18,90”
Fig. 4
• To fasten the product to the ground, use anchoring
plugs (
Fig.
_
4 ref. 1
) with a threaded shank M8 (UNC
5/16) suitable for the floor on which the tyre changer
will be fixed and in a number equal to the number
of fixing holes arranged on the bottom frame;
• drill holes in the floor, suitable for inserting the
chosen anchors, in correspondence with the holes
arranged on the bottom frame;
• insert the anchors into the holes made in the floor
through the holes on the bottom frame and tighten
the threaded elements;
• tighten the anchors on the base frame by applying a
torque equal to that indicated by the manufacturer
of the anchors.
LIBRAK350 - LIBRAK350PRO
1296-M024-01
