GB
Page 24 of 52
INSTRUCTION, USE AND
MAINTENANCE MANUAL
15.2 User control function
Wheel balancers can be used by 2 different users at the
same time, pressing the “user”
, key, selecting
user 1 or 2.
When the “user” key is pressed, the LED corresponding
to the selected user comes on.
Fig. 21
Selected user “1”
The system stores the data relating to the last per
-
formed spin according to the different operators. The
desired user can be called every time the program
displays the specific key. The measurements stored for
each user are lost when the machine is switched off.
User management is valid for any wheel balancer
function.
TO ENABLE OR DISABLE THE
“USER CONTROL” FUNCTION, SEE
PAR.
21.2.
IF THE FUNCTION IS
DISABLED, NO LED WILL COME ON
(FIG. 21), AND THE PRESSURE OF
“
” DOES NOT ENTAIL ANY
PROGRAM CHANGE.
15.3 Unbalance measurement
15.3.1 Indicative display of points where to
fit weight
IT IS VERY IMPORTANT TO RE-
MEMBER THE POINTS SELECTED
FOR MEASUREMENT INSIDE THE
RIM SINCE DURING THE WEIGHTS
FITTING AT "6 O'CLOCK" YOU
WILL NOT HAVE ANY OTHER REF-
ERENCE. THE POSITIONING IN
DEPTH WILL BE ANYWAY AT THE
DISCRETION OF THE OPERATOR.
Use keys
/
to set the value read on the
graduated scale on “D2” display.
The dimension entry for
ALU-2
and
ALU-3
mode is
completed.
To complete the entry of all the data necessary for
ALU1
or
ALU4
, modes, wheel width shall be entered.
Press key
to switch to the entry of the such
value.
Letter
will appear on “D1” display to indicate the
entry of the rated width value indicated on the rim.
The value on display “D2” starts flashing.
Input the nominal width shown on the rim, using the
keys
/
, or manually check by using the
graduated caliper, positioning it on the outer and in
-
ner side of the wheel (
Fig. 18
).
The dimension entry for
ALU1
or
ALU4
mode is
completed.
1294-M015-0_B
LIBRAK240RTLD - LIBRAK240RTLCD
