BUSKRO BK7IB-2, User Manual

Page: 18 / 97

Chapter 2 Operator Instructions Page 2-5
Left Side
Material Guide
Right Side
Material Guide
Mailpiece
Material Jam Switch
Side Guide Knob (4)
Figure 2-3:
Material Side Guides on the BK7IB-2
The material side guides, must be set correctly to ensure that the mailpieces are directed in
a straight fashion into the inkjet imaging area. In order to properly adjust the side guides,
the following steps are recommended:
1. Loosen and remove the guide fastening knob(s) on each material side guide.
2. Slowly feed a mailpiece onto the transport belts. Stop the transport base when
the mailpiece is between the side guides.
3. Place the left and right side guides about 1/16" to 1/8" from the corresponding
edge of the mailpiece. Ensure that the guides do not pinch the mailpiece
anywhere along its edges.
4. Replace the fastening knob(s) in the nearest threaded holes located in the base's
tabletop and tighten them to secure the guides.
5. Slowly dispense another mailpiece onto the transport belts and check that the
mailpieces path is unobstructed by the material side guides. If so, repeat steps 1
to 4.
Note: If the material side guides are improperly set, the mailpiece may become trapped
between them and/or cause a jam at the output of the feed rollers. If the material
side guides are incorrectly set, the Material Jam switch may be activated resulting
in a system stoppage.
In some cases, the side guides will need to be secured with one knob each (as
opposed to two) depending on the size of the mailpiece.
Buskro Ltd. BK7IB Inline Base