INSTRUCTIONS
Remove debris from tyre tread or sidewall using
the pair of pliers provided in the kit. Take care,
as residual air will escape under pressure.
Apply lubricant to the spiral shaft of the reamer
tool. This will help to probe the hole and
temporarily seperate the steel belts.
Insert the reamer into the puncture hole and
push in to clean out the hole. Reinflate tyre to
help with insertion of cord.
Thread the repair cord through the eye of the
insertion tool until equal parts are either side of
the tool. Lubricant may be added to the tip to
make insertion easier.
Firmly push the insertion tool and cord into the tyre.
A small amount of the cord should be visible.
(50-10mm only)
Remove the tool, by slowly pulling up on the
handle. The cord should remain stationary in this
process. Note: do not twist the handle. Trim the
excess protruding cord with the blade provided.
Reinflate the tyre using a Bushranger compressor
to the recommended tyre pressure and check for
leaks.
Check the repair regularly and have the tyre
professionally checked and repaired as soon as
possible. Seals are only intended to be used as
temporary repair.
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
5.
6.
