Bushnell 201360, Manual, Page: 15 / 96

15
TROUBLESHOOTING
If unit does not turn on - LCD does not illuminate:
• Depress POWER/FIRE button.
• Check and if necessary, replace battery.
If unit does not respond to key presses, replace the battery with a good quality 3 volt lithium battery.
If unit powers down (display goes blank when attempting to power the laser):
• The battery is either weak or low quality. Replace the battery with a good quality 3 -volt lithium battery.
If target range cannot be obtained:
• Make sure LCD is illuminated.
• Make sure that the POWER/FIRE button is being depressed.
• Make sure that nothing, such as your hand or
fi
nger, is blocking the objective lenses
(lenses closest to the target) that emit and receive the laser pulses.
• Make sure unit is held steady while depressing the POWER/FIRE button.
NOTE:
The last range reading does not need to be cleared before ranging another target. Simply aim at the new target
using the LCD s reticle, depress the POWER/FIRE button and hold until new range reading is displayed.
Speci
fi
cations, instructions, and the operation of these products are subject to change without notice.
.
.
.
.
.
.
.
.
‘