With the engine off, complete the following steps:
• Connect the hydraulic lines from the power pack and blower to the connector hoses
• Make the electrical connection from the blower to the extension harness
• Connect the 12 volt battery cables to either the battery or a suitable positive and negative electri-
cal connection with a minimum 25 amp capacity. Clamp wires are red sleeved for po bat-
tery terminal and green sleeved for negative terminal or ground.
• If you have the full duty power pack, make the power connection if required.
Enter the power unit, fasten safety restraints and start the engine:
• Carefully move the loader arms through its entire range of motion, carefully noting any pinch,
stretch or kink points on the hydraulic hoses or harness, make adjustments as required.
• Slowly lift the power pack until the gearbox shaft is at the same height as the PTO output on the trac-
tor, c
arefully noting any pinch or stretch points on the harness,
• Engage the power pack and set the RPM at 540 MAX.
•
Test the Function of the control handle, adjust the diverter and chute.
!
CAUTION
Operational Hazard
Tractor PTO must operate
at 540 RPM only. Exceeding
the snow blower’s design
speed of 540 RPM will result in operator
injury or damage to the machine.
Test
!
WARNING
High Pressure Hazard
Be aware that hydraulic leaks could
develop with out warning. Do not
check for leaks with your hand or
fingers while the system is pressurized
!
CAUTION
Operational Hazard
At first use the hydraulic components and hoses on this
product may contain air or an
air-fluid mixture. Failure
to remove all the air from the hydraulic components can
cause dangerous uneven, jerky movement during use
or unwanted movement when not being operated.
The right switch
controls the left or
right rotation of the
chute.
The left switch con-
trols the up / down
direction of the
snow diverter.
24
Summary of Contents for SBLM66
Page 35: ...Notes 35...
