ASSEMBLY
DSP8/10/12 10/19
Assembly Section 3-6
© 2019 Alamo Group Inc.
A
SS
EM
B
LY
Transporting
When traveling on public roads at night or during the day, use accessory lights and devices
for adequate warning to operators of other vehicles. Comply with all federal, state and local
laws.
1. Always raise scraper up and install cylinder
transport lock (#1) on lift cylinder (#3) before
traveling on roadways or long distances.
Secure transport lock with wire retaining pin
(#2).
2. Select a safe ground travel speed when
transporting from one area to another.
3. Be sure to reduce tractor ground speed when
turning; and leave enough clearance so the
scraper does not contact obstacles such as
building, trees or fences.
4. Shift to a lower gear when traveling over
roughly or hilly terrain.
5. When traveling on roadways, transport is such
that faster moving vehicles may pass you
safely.
Field Set-up
The following operational procedures should be carried out by the tractor operator. Other
persons should be cleared of the area even during scraper set up. All scraper operation
including field set up should be stepped when in the vicinity of other persons.
1. Raise scraper up to release any tension on the transport lock. Remove wire retaining pin and transport lock
from lift cylinder.
2. Install transport lock on the storage gusset and secure with wire retaining pin.
Unhooking from the Tractor
Always engage parking brake, shut off tractor, and remove key before dismounting from
tractor to unhook equipment.
1. Park Pull Type Drag Scraper on a level solid hard surface.
2. If optional tilt axle cylinder is included, fully retract cylinder to level the scraper’s cutting edge.
3. Retract lift cylinder to lower scraper unit until cutting edge is resting on the ground and hitch weight is off
the tractor drawbar.
4. Shut tractor off before removing hitch pin and safety chain.
5. Move tractor forward until tractor drawbar is clear of scraper hitch. Do not travel so far forward as to cause
the hydraulic quick release couplings to connect.
6. Use lift control lever to lower scraper until scraper blade and side plates are resting on the ground.
7. Shut tractor engine off. Operate control arms back and forth to release all hydraulic line pressure.
8. Unhook hydraulic hoses from tractor. Store hose ends in hose support loop. Store hitch pin with scraper. If
hitch pin is used with other equipment, store hitch pin with the tractor.
9. Drive tractor carefully away from scraper.
Summary of Contents for DSP10
