3 | Transport
6 / 28
Instruction Manual R5 RA 0155 A_EN_en
2.4.3 Temperature Switch "Oil"
The temperature switch monitors the oil temperature of the machine.
Depending on the oil type, the machine must be stopped when the oil reaches a certain
temperature, see
.
2.4.4 Resistance Thermometer
The resistance thermometer monitors the oil temperature of the machine.
Depending on the oil type, warning and trip signals must be set, see
2.4.5 Level Switch
The level switch monitors the oil level.
The machine must be stopped when the oil level is too low.
3
Transport
WARNING
Suspended load.
Risk of severe injury!
• Do not walk, stand or work under suspended loads.
WARNING
Lifting the machine using the motor eye bolt.
Risk of severe injury!
• Do not lift the machine using the eye bolt fitted to the motor. Only lift the machine as
shown.
NOTICE
In case the machine is already filled with oil.
Tilting a machine that is already filled with oil can cause large quantities of oil to in-
gress into the cylinder. Starting the machine with excessive quantities of oil in the
cylinder will immediately break the vanes and ruin the machine!
• Drain the oil prior to every transport or always horizontally transport the machine.
• Make sure that the eyebolt(s) (EB) is/are in faultless condition, fully screwed in and
tightened by hand.
Summary of Contents for R5 RA 0155 A
Page 26: ...Note ...
Page 27: ...Note ...
