35
Audio
In this area you have the possibility to change the audio settings of the
HFCK.
The HFCK is sold with four
Ringtones
from which you can respec-
tively select one. With
„NEXT“
or
„PREVIOUS“
you can navigate in
the list. With
„ACCEPT“
the ring tone is selected. If you would like to
use your mobile phone’s ring tone, please select the first entry in the
menu. Please remember, however, that not every mobile phone can
transfer its ring tone to the HFCK.
The
volume level
for the voice feedback and the selected ring tone
can be set in an additional sub menu. The volume of the beeper that
gives the signals for speed control and for the hazardous zones can also
be set here in the same way.
Available as voice commands are
„LOUDER“
,
„LESS“
,
„MAXIMUM“
,
„MINIMUM“
and
„ACCEPT“
.
For some radios it may cause problems if the HFCK starts with voice
response immediately after the mute signal. Some radios need some
time for a corresponding activation and reaction to the mute signal.
This will be indicated to you through the fact that you don’t hear the
signal tone at the start of the voice control. To avoid this effect, you can
enter a maximum delay of up to three seconds in the
„MUTE DELAY“
menu item. It is only after this time has elapsed that the HFCK begins
with the voice feedback.
Certain mobile telephones offer the possibility of being able to install and
operate a navigation solution. On many mobile phones, the suggested
directions are only transferred via the
Bluetooth
A2DP profile. If you
have not connected a suitable cable to the LINE-OUT output of the HFCK
and to the radio however, you are not able to hear these instructions.
With the
External Audio
menu item, it is possible to place these in-
structions on the PHONE-OUT output of the HFCK. This means that the
direction instructions are read out in monotone and the radio is also
muted. The HFCK takes priority with its functions, however, which means
that if the voice control is active or in the event of an incoming call, any
direction instructions that are being issued at that time will be muted.
Please note:
If the function is activated it is not possible to listen to
X
music via A2DP via the LINE-OUT output.
Audio
Ringtones
Play
Select
Volume
Speech
Ringtone
Mute delay
External audio on
