Burster DIGIFORCE 9311, Operation Manual, Page: 46 / 216

46
of 216
6.1.2 PLC outputs
In the menu "Assignment of the PLC outputs" (M37), you can customize which signals appear at certain
PLC outputs. You cannot change the settings for pins 12 and 14 to 19.
You have the option to assign a different signal to pins 20 to 25 from the following:
Signal Description
OUT_OK_STEST Sensor test OK
OUT_STROBE Validity signal for echoed measurement program number
OUT_PROG0 Bit 0 of echoed measurement program number
OUT_PROG1 Bit 1 of echoed measurement program number
OUT_PROG2 Bit 2 of echoed measurement program number
OUT_PROG3 Bit 3 of echoed measurement program number
OUT_MEAS_ACT Measurement in progress (measurement active)
OUT_S3 Switching signal S3
OUT_S4 Switching signal S4
OUT_S5 Switching signal S5
OUT_S6 Switching signal S6
OUT_TEST_OP The 9311 is in test mode
OUT_ERROR Fault / error
Possible causes:
• Measurement started when READY = 0
• Measurement-channel overdrive
• Device error during boot-up
OUT_WARN_TARE Warning that tare limit reached
OUT_CONFIG The 9311 is in configuration mode
OUT_ACK_ALARM Alarm output from Acknowledgement function
OUT_ACK_LOCK Lock output from Acknowledgement function
OUT_ACK_OK OK output from Acknowledgement function
OUT_ACK_NOK NOK output from Acknowledgement function
OUT_PC_LOG Data logging on PC (DigiControl measurement mode enabled)