106
of 216
6.3.2 Measurement mode
In the "Measurement mode" menu (M19) you can specify the signal acquisition parameters for the
measurement phase. Essentially the parameters you need to set are the signal sampling, the X-reference
for the measurement curve, the curve segment (just the forward curve or the entire measurement curve)
and the start/stop condition for the measurement phase.
1
In measurement mode, tap anywhere on the touchscreen. The icon appears in the
bottom-right corner.
2
Tap to open the "Configuration Main Menu".
3
Tap the "Program Setup" icon.
4
Tap the "Measmnt mode" icon.
5
In the list of elements, tap the element that you wish to enable, disable or edit, then make the
changes you require.
6
Tap to return to the "Program Setup" menu.
The settings that you can make are described in greater detail below.
Summary of Contents for DIGIFORCE 9311
Page 3: ...3of 216...