burroughs smartsource series, Installation And Operation Manual

Page: 30 / 74

Operating the Unit
2-16 4326 9562-007
Remove Items from Pocket and Check Work (All Units)
To prevent jams, you should remove items from the pocket when the pocket is nearly full. Pocket
capacity is approximately 100 items. Verify that endorsements are clearly printed, and that image
quality is acceptable (if the application allows image viewing.)
Stopped Document in Track Conditions
If an item stops in the track, or does not fully enter a pocket, it must be removed from the track
before documents can flow again.
Note: When this happens, you must check your application documentation for
information on clearing stopped items and perform the necessary recovery steps .
The item may have stopped in the track due to one or more of the following:

Unacceptable size

Creases, folds, curls, or dog-ear corners

Rubber bands, paper clips, staples, or foreign objects

Check stubs or adding machine tapes

Torn or damaged paper

Missing or misaligned inkjet cartridge when endorsement is enabled
Prepare items properly for flow to prevent or minimize document stops in the track. See “Document
Preparation” earlier in this section.
If there are repeated problems with documents moving through the track, see Section 5
of
this guide, “Jams or Unexpected Document Stops.”
If a document stop or exception condition occurs, check these software utilities (if installed) for
additional information:

Update Monitor (Expert units)

SmartStats (Professional and Value units)