U
ŽÍVATEĽSKÝ MANUÁL MIEŠAČOV - MODELY R6202A, R6202B
Page 18 of 19
_ We recommend that you always clean the unit immediately after using it.
_ Clean the unit regularly by rubbing it with a damp cloth and a little soft soap. Do not use
cleaners or solvents; these will attack the plastic parts in the unit. You must also ensure that
water cannot get into the inside of the unit.
Carbon brushes
_ If excessive sparking occurs you must have the carbon brushes checked by a qualified
electrician.
Attention! Only a qualified electrician is allowed to change the brushes.
Maintenance
_ There are no parts fitted inside the unit that require maintenance.
9. CORRECTIVE ACTION IN CASE OF FAILURE
(1) The operating switch is switched on, but the motor is not working.
-- Wires in the mains plug or in the socket are loose.
Have socket and plug checked or repaired.
-- The switch is faulty.
Have the switch replaced.
(2) The operating switch is switched on, but unusual noises can be heard, the motor is not
working or only very slowly.
-- Switch contact has failed.
Have the switch replaced.
-- Component jammed.
Have the electric tool checked or repaired.
-- Too much thrust, as a result the motor is dragging.
Use less thrust during the task.
(3) Motor gets hot.
-- Foreign substances have got inside the motor.
Have the foreign substances removed.
-- Lack of or contaminated lubrication grease.
Have lubricating grease applied or replaced.
-- Pressure too high
Use less thrust during the task
(4) Frequent or strong sparks on the commutator.
-- Short circuit on the armature.
Have the armature replaced.
-- Carbon brushes worn out or jammed
Have the carbon brushes checked.
-- Rough running of the commutator.
Have the surface of the commutator cleaned or ground.
For your own safety, never remove parts or accessories of the electric tool during operation.
In case of fault or damage have the electric tool repaired only by a specialist workshop or
by the manufacturer.
