68
Start-up
Type 8792, 8793 REV.2
14.4.2.1.
X.TUNE.CONFIG
– Manual configuration of
X.TUNE
This function is needed for special requirements only.
For standard applications the
X.TUNE
function (automatic adjustment of the positioner), as
described above, is run using the factory default settings.
The description of the
X.TUNE.CONFIG
function can be found in Chapter “26.3. Manual configuration of
X.TUNE”.
14.5
Activation of the process controller
The process controller is activated by selecting the
P.CONTROL
auxiliary function in the
ADD.FUNCTION
menu.
The activation transfers
P.CONTROL
into the main menu (MAIN) where it is available for further settings.
Activate the process controller as follows:
→
Press
MENU
for 3 s. Switching from process level
setting level.
→
/ Select
ADD.FUNCTION
.
→
Select
ENTER
. The possible auxiliary functions are displayed.
→
/ Select
P.CONTROL
.
→
Select
ENTER
.
P.CONTROL
is now marked by a cross .
→
Select
EXIT
. Acknowledgment and simultaneous return to the main menu (MAIN).
P.CONTROL
is now activated and incorporated into the main menu.
You have activated the process controller.
Following activation of
P.CONTROL
, the
P.Q‘LIN
and
P.TUNE
menus are also available in the main
menu (MAIN). They offer support for the setting of the process control.
P.Q‘LIN
Linearization of the process characteristic
Description see chapter “25.4”
P.TUNE
Self-optimization of the process controller (process tune)
Description see chapter “25.5”
ADD.FUNCTION –
Add auxiliary functions
Apart from activating the process controller,
ADD.FUNCTION
can be used to activate auxiliary functions and
incorporate them into the main menu.
The description can be found in chapter “26. Configuring the auxiliary functions” on page 78.
english
Summary of Contents for 8792
Page 196: ...www burkert com ...
