Bürkert 8619 multiCELL WM AC, Operating Instructions Manual

Page: 141 / 194

8.11.14 Entering the periodicity of a maintenance operation to be
carried out on the sensor connected to the analogue input
Refer to section 8.9 to access the "Calibration" menu.
Calibration intervals Maintenance
ENTERING
Reset Mainte-
nance Timer
Yes/No
Calibration Mx:Inputs AI1/AI2 Mode:general
Mode:chlorine
On each due date, the 8619 generates a "maintenance" event, signalled on the display by the icon , and a
"warning" event, signalled on the display by the icon
.
→ Enter the number of days between two maintenance reminders.
When the maintenance operation has been performed, you can choose ("Yes") or not ("No") to restart the
countdown of days until the next maintenance operation in the menu "Reset maintenance Timer".
→
Select "Reset Maintenance Timer" -> "Yes" or -> "No"
→ Enter "0000 days" to disable the automatic reminder for the maintenance operation.
8.11.15 Restoring the factory calibration of the analogue inputs
Refer to section 8.9 to access the "Calibration" menu.
Yes/No Factory calibr. Calibration Mx:Inputs AI1/AI2 Mode:general
Mode:chlorine
8.11.16 Resetting the totalisers
This function is available on the devices with analysis modules if the software option, "FLOW", is activated. See
section 8.10.4
Refer to section 8.9 to access the "Calibration" menu.
Calibration
DI1/2 totaliser Reset totalis. A
M0:Inputs
Reset totalis. B
Yes/No
Yes/No
Mx:Inputs
141
Adjustmentandcommissioning
Type 8619
English