Bürkert 8619 multiCELL WM AC, Operating Instructions Manual, Page: 103 / 194

.
.
.
Parameters Functions F1...F12:
PID
Setup
This is
when the
device is be-
ing parame-
tered............
....................
This is
when the
device is be-
ing parame-
tered............
....................
CutOff: Mode:
Cut-:
Cut+:
Cut-
OFF
Cut-Cut+
Cut+
ENTERING
ENTERING
SP limits: State:
SPlimits-
S:
ON
OFF
ENTERING
ENTERING
Inversion ON
OFF
CMD SAFE Mode:
Channel 1/2:
ON
OFF
ENTERING
Advanced
Channel 1/2:
SP LIMITS : Set the low and high limits of the setpoint value in order to limit the working range of the setpoint.
CUTOFF : Force or do not force the module output to 0% or 100% if the setpoint value is outside a range defined
by "Cut-" and "Cut+", or under the low range "Cut-", or above the high range "Cut+".
100
99
98
97
96
5
4
3
2
1
100
99
98
97
96
5
4
3
2
1
Cut-
Cut+
Cut-
Cut+
setpoint (SP)
setpoint (SP)
Fx: (CMD) (%) Fx: (CMD) (%)
Fig. 69 : "CUTOFF" graphs
CMD SAFE : Confirm (select "Mode: ON") or do not confirm (select "Mode: OFF") the use of a fallback position
on the output when the "System switch" event (see section 8.10.18) has the state "ON". When use of the
fallback position is confirmed, enter a fallback position value of between 0 and 100% for each output.
103
Adjustmentandcommissioning
Type 8619
English