Bürkert 8228 ELEMENT, Quick Start Manual, Page: 26 / 32

26
Operatingandcommissioning
Type 8228
9.3 using the dynamic functions
you want to... choose...
...go back to the Process level, without
confirming the modifications made dynamic function "MEAS"
...validate the input dynamic function "OK"
...go back to the parent menu dynamic function "BACK"
... abort the current operation and
go back to the parent menu dynamic function "ABORT"
...answer the question asked dynamic function "YES" or "NO"
9.4 knowing the display
OP
EN
LOC
K
CondS
0.000 µS/cm
tempc
23.8 °c
ERR
Red LED:
shows an error
not used
Yellow LED:
shows that transistor 1
is switched
Yellow LED:
shows that transistor 2 is
switched
Fig. 19: Position of the symbols and description of the LEDs on the display module
Red LED:
shows an error
Yellow LED: shows that
transistor 2 is switched
Green LED: shows that
the device is energized Yellow LED: shows that
transistor 1 is switched
Fig. 20: Description of the LEDs on the electronic board
The LEDs of the display module are duplicated on the elec-
tronic board that is located under the display module: these
LEDs can only be seen if the device has no display module.
English