Burkert Type MS01, Operating Instructions Manual, Page: 60 / 88

60
General settings - Diagnostics
→ Go to device pH sensor MS01 function general settings tab Diagnostics .
→
Select büS status .
→
Select Reset error counter .
→ Confirm with
save
or cancel with
cancel
.
The 2 maximum error counters are reset.
14.9 Read whether the measured process data is sent on
büS or on the CANopen fieldbus
To read out whether the measured process data (PDO, process data object) is sent on büS or on the
CANopen fieldbus, do the following procedure:
→
Go to device pH sensor MS01 function general settings tab Diagnostics .
→ Select büS status and read the value of the parameter CANopen status .
•
If the CANopen status is Operational, the PDOs are sent to büS or to the CANopen fieldbus.
•
If the CANopen status is Pre-Op (pre-operational), the PDOs are not sent on büS or on the CANopen
fieldbus and the message büS is not operational is generated in the message list. Refer to chpt. 19.1.4.
14.10 Read the generated events
2 types of events can be generated: events that are related both to the system and to the product and
events that are related to the product.
•
To read the events that are related both to the system and to the product, do the following procedure:
→
Select in the top of the display.
The Messages overview is displayed.
Back to previous view
Event message
Bürkert-internal code
Time at which the event
occurred
Messages overview
15 Messages
Capteur Chlore
Disinfection Sensor MS02
Message büS event: büS is NOT operational
Time 09.03.2036 - 07:28:19
Signature 16:45:256:SMn:0
Controller.1050
1
ME23 NEXT Pro DP
2
005676261211
300
Controller.1050
1
Messages
Selected event and device that has generated the event
Symbol related to the event
status. Refer to Table 15
Fig. 19: Message overview
English
Type MS01