Burkert FLOWave S 8098, Operating Instructions Manual

Page: 141 / 192

141
SAW sensor - Maintenance
Type 8098
15.9 Resetting the flow rate calibration data to its default
values
To reset all the flow rate calibration data to its default values, do the following:
→
Select the device in the navigation area.
→ SAW sensor
→
Maintenance
→ Calibration
→
Stand. meas. values
→ Flow rate
→
Reset to default
→ Finish
All the flow rate calibration data is reset to their default values.
15.10 Setting the offset value of the liquid temperature
Instead of setting the offset value of the liquid temperature, you can calibrate it. See chpt. 15.11 Calibrating
the offset value of the liquid temperature .
To enter an offset value for the liquid temperature, do the following:
→
Select the device in the navigation area.
→ SAW sensor
→
Maintenance
→ Calibration
→
Stand. meas. values
→ Temperature
→
Offset
→ Enter value
→
Set the value of the offset.
→ Finish
The offset value of the liquid temperature is set.
English